What is a cyclone cell wheel sluice?
A cyclone cell wheel sluice is a device installed under filters or cyclones that separates powdered or granular bulk solids from the air.
How and where are cyclone cell wheel sluices used?
Airlocks, cyclone cell wheel sluices and star feeders can be made in ST37 and ST52 carbon steel, Hardox, Ni-Hard and AISI 304 / AISI 316 stainless steel. Bearing and sealing types (mechanical seals, lip seals, etc.) may also vary with the process. Cell wheel sluices used in hot processes or for conveying highly abrasive materials are built with different features.
Rotors can be supplied with bladed, rounded, adjustable, scraper and polyamide vanes, among other options. The reason cyclone cell wheel sluices come in so many versions lies entirely in the material being conveyed and the process. This matters so much that a wrong choice can even damage the conveyed material. Standard solutions may work well for conveying flour, cement and many other materials, but slightly different granule sizes or material properties can mean these devices fall short. Cell wheel sluices must therefore be selected with great care to suit the process.
Process-specific cyclone cell wheel sluices
Airlock, rotary valve and cell wheel sluice rotor types
-

- A1-A2-A3: Open vanes
B1-B2-B3: Radiused (oval) vanes
C1-C2-C3: Adjustable and replaceable vanes
D1: Rotary valve with closed or adjustable rotor (dosing)
Rotary Valve – Airlock
The type that takes product in at the top and discharges it at the bottom (also referred to as an airlock or rotary valve).
Blow-Through Rotary Valve
The type that takes granular or powdered raw material from the top of the unit and discharges it at the bottom by gravity and mechanical action (also known as an airlock or cell wheel sluice; the only difference is that, being used in pneumatic lines, it has pipe inlet/outlet connections or an eductor). Its design and sealing elements are built for pneumatic conveying.
Wear-Resistant
Products

Rotary valves are mainly used to discharge material collected in pulse-jet filters and cyclones, in separators, and to feed material from hoppers into the pneumatic line; in short, to separate dusty material from the air and for gravimetric dosing.
Pneumatic conveying processes differ by phase and also vary within the same phase. In low-pressure, i.e. dilute phase conveying, rotary valves can be classified into two groups: vacuum and pressure. Although minor, this classification leads to differences in rotary valve design. We therefore build the rotary valves for vacuum and pressure lines to suit your process.
