What Is a Double Flap Discharge Valve?
The flap airlock, also called a pendulum flap valve, is generally used in processes where a rotary valve (airlock) is not up to the job. Standard rotary airlocks get damaged when conveying and discharging abrasive and coarse bulk raw materials, which can bring the process to a standstill. The main problems with rotary valves, and the situations that call for a double flap valve, are:
1- Product getting trapped between the housing and the vanes
2- Very sticky product remaining between the vanes and filling the pocket volume
3- Product damaging the housing because of its shape
4- Product preventing the rotary valve from turning
5- Thermal expansion adversely affecting the operation and tolerances of the valve

Double flap valves are used in processes where coarse products must be discharged; under hoppers, filters and silos that require an airtight seal; in vacuum and pressure processes; in interconnected processes operating at different air pressures (vacuum conveyor, pressure conveyor); and with bridging, poorly flowing products. Thanks to their double-flap design, they are preferred for both feeding and discharging and provide a good seal. In short, they operate as a batch process in their own right.
Airlock – Dump Valve – Pendulum Flap Valve – Double Flap Valve Working Principle
Built in square or round construction, this unit works as follows: the raw material to be conveyed first drops into the upper chamber; the upper flap is then opened by a pneumatic or electric actuator, allowing the material to fall under its own weight into the section containing the second flap. The upper flap then closes. On electric models this closing is by spring return or counterweight. Once the upper flap has completed its opening and closing cycle, the same cycle is repeated for the lower flap.
In short, the product is lowered periodically from top to bottom in stages and in sequence. This cycle can range from 2 to 6 times per minute. Because at least one of the flaps separating the zones is always closed during discharge or feeding, a seal is maintained. The degree of sealing depends on the type of product.- Double Flap Valve and Pendulum Flap Valve Flap Types
- 1- ST37-42, Hardox and alloy steels
2- AISI 304 / AISI 316 stainless steel
3- Ulpolen, PTFE and sintered linings
Wear-Resistant
Products


Flap valves and pendulum flap valves in all the sizes we produce can be built with the optional features you require.
Although double flap valves vary in their features, they fall into two main groups: electrically and pneumatically actuated. They also differ according to the product properties, pressure and temperature of the process in which they will be used. Flap and valve bodies can be made of ST47, ST42, AISI 304 or AISI 316.
Double flap valves have one pneumatic cylinder and one solenoid valve for each flap plate. Valve timing is controlled by an electronic signal sent to the solenoid valves. This mode of operation is designed to ensure the valve opens and closes its flaps at the right time and in the right sequence.