PVC, Plastic Raw Material and Hot-Cold Mixer Feeding Systems
Extruders run on blends prepared according to a recipe. If the blends feeding the extruders are plastic-based, they come from dryers and dosing units or from mixers. The raw materials used can vary, for example PE, PU, PP, PET or PVC.
These mixers can be of various designs, such as hot-cold mixers, horizontal, vertical or Y-type (trouser-leg) mixers. The raw material feeding system may also handle recycled materials from the process, such as flakes and regrind.
All these process steps require an infrastructure. While extruder 1 runs one recipe, extruder 2 may run a different one. To make this possible, the blending, the dosing system and the raw material automation behind the scenes must be designed correctly. We are your solution partner at every step, from loading raw materials delivered in big bags or sacks into silos and feeding the mixers, to everything between the mixer and the extruder. In the automotive and plastics sector, the process differs: material is fed to dryers and then on to the extruders.

This is why it is important to prepare the blends of PVC and auxiliary raw materials correctly upstream of the extruder.
We dose and convey powder and liquid raw materials to the blending mixers using isolated load cell systems, and we deliver the recipe blends completed in the hot and cold mixers to the extruders using various conveying methods (mechanical, pneumatic).
Depending on the requirements, recycled raw materials such as edge trim from the process, material from granulators or flakes can also be fed into the system.
Plastic Raw Material Automation
Conveying Systems

PVC Mixer – Blend Automation System
Stable blend ratios in your products are directly proportional to
the quality of your work. At first glance, using more raw material than necessary may seem to improve product quality, or your process tolerances may compensate for such errors. But whether or not there is room to compensate, you should use exactly the targeted amount of each material in your blends, first time. To reach this goal and avoid any incorrect blend ratio, whether too little or too much, you need the right methods and tools.
Whether your raw material is a powder such as PVC or a cylindrical granule such as PE, PP or PET, we are your solution partner at every process step before it enters the extruder.
